Slide 1 Slide 2 Slide 3 Slide 4 Slide 5 Slide 6 Slide 7 Slide 8 Slide 9 Slide 10 Slide 11 Slide 12 Product List
des the gap
Please ensure there is at least a 1mm gap between the switch and any adjacent component. Also, when designing the set, please do not design so the switch actuator is in a normally depressed state. Depressing the switch’s actuator for long periods of time can damage the internal spring. When designing the actuation, please ensure about 0.3mm less than the full travel of the switch.
PTM Published on: 2017-11-07